Step 1
Take either one strip or 2 light/dark strips and a comb and thread the strip below 2 teeth and over 2 teeth and down. Turn the comb to the side where the strip came out .
Step 2
Loop it back and glue it on the flat side with the tiniest bit of glue. If you are using 2 strips make sure both strips are glued. Now fold the strip forward and take it under 2 teeth and over 2 teeth and down again, loop it back and paste on the flat side same as before.
 |
| After 1st loop is pasted |
 |
| second loop folded but not pasted |
 |
| After 2 loops are pasted |
Step 3
Continue the process till you get the sprig the size you want. Remove from comb. It should look like the pic below. You can see where I have looped and glued and then folded forward as this makes up the stalks of the leaves. |
| Removed from comb after 2 loops (leaves) are pasted |
 |
| Completed one side |
Step 4
Repeat the process with a separate set of strips and then paste them both together to form the leaf sprig as shown below.
Repeat the process with a separate set of strips and then paste them both together to form the leaf sprig as shown below.
 |
| After both half sprigs are pasted |
0 nhận xét:
Đăng nhận xét