Please refer my tutorial here to make a stem using only 3mm strips. If you apply a light coat of glue with a brush and allow it to dry it will make very firm stems.
If you wish to have wire stems, take very thin wire and apply glue to a 3mm strip and wrap it around the wire while holding the strip at a 135 degree angle.
STEPS
Cut the stems to the required size.
Take a strip and glue the edge to top of the stem as shown and let it dry.
Roll it into a peg by hand or using the quilling tool. Do not tighten too much nor make it too loose. If done right, you will end up with what looks like the above.
Hold the peg as shown above and roll it forward and backwards applying slight pressure inwards or slightly squashing it and it will push down like a cup. Roll gently and repeatedly till you get the required depth . Do not squash.
Once done it will look like the above- your stem.
Now put some glue into the cup and around the edges. Also apply glue to the center of the flower and allow the glue to sit a tad till it gets sticky.
Now stick the stem onto the flowers and allow it to dry completely. If you have long stamens sit it on a hollow cylindrical object so your middle does not get damaged.
Once dry you can hold it up like shown above.
ATTACHING SEPALS
Take a 3mm strip or any other size strip you desire and fold it into 5 or 7 equal pieces as shown.
Keep together and cut to shape as shown above.
Shape the sepals by rolling the end of your quilling tool over the sepals to curl it and roll on the other side at the bottom to curl in reverse to form an asymmetrical S.
Now glue it as shown from the bottom of the cup and shape each sepal as desired.
That's it folks!! Hope You found this tutorial useful. If you did, would love to have your comments as it means a lot to know what you think.
0 nhận xét:
Đăng nhận xét